Calculating Focal Length and Minimum Diameter for Laser Beam Diffraction

AI Thread Summary
To calculate the focal length for focusing a helium-neon laser beam to a 10 micrometre diameter spot at 8.0 cm, the relevant equations involve the parameters of wavelength and diameter. The equation w = (2.44lambda * focal length) / diameter is central to the calculations. An attempt to solve for focal length using 2.5lambda yielded an answer of 0.001 cm, but this result was not confirmed by others in the discussion. Participants expressed difficulty in finding modifications or alternative methods for the equations provided. Clarification on the correct application of these formulas is needed to resolve the calculations.
strikingleafs01
Messages
7
Reaction score
0

Homework Statement



A scientist needs to focus a helium-neon laser beam (lamda = 633nm) to a 10 micrometre diameter spot 8.0 cm behind the lens.

a) What focal-length should she use?
b) What minimum diameter should she use?

Homework Equations



w = (2.44lambda * focal length) / diameter

theta = 1.22lamda/diameter

Wmin is apprx equal to 2.5lambda...apparently, but if you have a separate method ignore this.

The Attempt at a Solution



i attempted to calculate w through 2.5lambda, then use that to calculate the focal length. the answer i got was 0.001cm.
 
Physics news on Phys.org
I cannot seem to find any modification of this equation anywhere, but it seems that this is the only equation that is used to solve this problem
 
Oh! So did you get the right answer using that formula?
 
nope, still nothing, anyone know anything??
 
I multiplied the values first without the error limit. Got 19.38. rounded it off to 2 significant figures since the given data has 2 significant figures. So = 19. For error I used the above formula. It comes out about 1.48. Now my question is. Should I write the answer as 19±1.5 (rounding 1.48 to 2 significant figures) OR should I write it as 19±1. So in short, should the error have same number of significant figures as the mean value or should it have the same number of decimal places as...
Thread 'A cylinder connected to a hanging mass'
Let's declare that for the cylinder, mass = M = 10 kg Radius = R = 4 m For the wall and the floor, Friction coeff = ##\mu## = 0.5 For the hanging mass, mass = m = 11 kg First, we divide the force according to their respective plane (x and y thing, correct me if I'm wrong) and according to which, cylinder or the hanging mass, they're working on. Force on the hanging mass $$mg - T = ma$$ Force(Cylinder) on y $$N_f + f_w - Mg = 0$$ Force(Cylinder) on x $$T + f_f - N_w = Ma$$ There's also...
Back
Top