At Center of Convex Lens & Glass Plate: What is Observed?

AI Thread Summary
When a convex lens is placed on a flat glass plate and illuminated with monochromatic red light, concentric bands of red and dark are observed. At the center of the lens, where it contacts the glass plate, there is a thin layer of air that causes light to reflect at both the lens/air and air/plate boundaries. The interference between these two reflections creates a phase difference that affects the observed patterns. Understanding this phase difference is crucial for analyzing the resulting interference patterns. The discussion highlights the complexity of light behavior in this setup and the need for further exploration of the reflections involved.
skrewd1
Messages
5
Reaction score
0
A convex lens is placed on a flat glass plate and illuminated from above with monochromatic red light. When viewed from above, concentric bans of red and dark are observed. What does one observe at the exact center of the lens where the lens and the glass plate are in direct contact.
 
Physics news on Phys.org
There is a thin layer of air between the surfaces, thus light reflects at the glass/air boundaries. The first reflection is at the lens/air boundary, the second at the air/plate boundary. Consider the interference between these two reflections. (What is their phase difference?)
 
bump
Still can't figure out :mad:
 
What have you done so far? What can you say about the two reflections?
 

Thread 'Rolling without slipping on a curved surface'

Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
View full post »
Thread 'Voltmeter readings for this circuit with switches'

Thread 'Voltmeter readings for this circuit with switches'

TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
View full post »

Similar threads

Lens Maker's Formula - Confusion in the derivation
Replies
15
Views
1K
Calculating Chromatic Aberration
Replies
2
Views
1K
Plano-convex lens with phase changes
Replies
22
Views
2K
Understanding Two Convex Lenses: Ray Diagram and Focal Lengths
Replies
3
Views
2K
Image with an Plano-Convex lens
Replies
7
Views
3K
Image position in an optical system?
Replies
5
Views
2K
5 Questions dealing with Optics, image included
Replies
1
Views
3K
Image Distance with two concave lenses
Replies
4
Views
4K
Finding the optical power of a contact lens
Replies
1
Views
5K
Divergine Lens Embedded within Converging Lens
Replies
1
Views
1K

Hot Threads

Recent Insights

Back
Top