Energy Conservation - Electric Potential Energy

AI Thread Summary
In proton-beam therapy, a proton beam is used to deposit energy into a tumor, specifically 0.10 J in this case, by accelerating protons through a 13 MV potential difference. The relationship between energy, charge, and potential difference is expressed by the equation E = qv, where q is the total charge. The initial calculation yielded a charge of 7.0x10^-9 C, which was incorrect due to a miscalculation. The correct total charge required to deposit the energy is 7.7x10^-9 C. Accurate calculations are essential for effective treatment planning in proton therapy.
darkblue
Messages
30
Reaction score
0

Homework Statement



In proton-beam therapy, a high-energy beam of protons is fired at a tumor. The protons come to rest in the tumor, depositing their kinetic energy and breaking apart the tumor’s DNA, thus killing its cells. For one patient, it is desired that 0.10 J of proton energy be deposited in a tumor. To create the proton beam, the protons are accelerated from rest through a 13 MV potential difference.


What is the total charge of the protons that must be fired at the tumor to deposit the required energy?
Express your answer to two significant figures and include the appropriate units.


Homework Equations



U = qv
KE = 1/2mv^2

E = 0.10 J
change in v = 13 000 000 V


The Attempt at a Solution



I took 0.10 J as the total energy, seeing as this is the amount that must be deposited in the tumor. The protons start from rest, so KE = 0 while U = qv, where q is the total charge of the protons and v is the potential difference, which is 13x10^6 V.

E = qv
0.10/13000000 = q
q = 7.0x10^-9 C

This is not the right answer though...is there something wrong with my logic?
 
Physics news on Phys.org
You did the calculation wrong. Recheck.
 
I don't quite understand what I've done wrong. I did the calculation again and I'm still getting 7.0x10^-9 C. I'm assuming the units of C are correct since the division yields Joules/Volt, and Joule = Coulomb * Volt. I also checked over my conversion of MV to V and that is correct as well.
 
"Express your answer to two significant figures and include the appropriate units."

It should be 7.7x10^-9 C
 
Oh I see...my calculator didn't show me those last few digits. Thanks so much for your help!
 
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
Back
Top