Flow of water vs mercury vs treacle

AI Thread Summary
The discussion centers on the flow rate of liquids through a hole in a cylinder, specifically comparing water, mercury, and viscous substances like treacle. The formula for volume flow rate, Q = Pi*r^2 * (sqrt(2gh)), indicates that velocity is influenced by the height of the water column, not the liquid's density. However, the conversation raises the question of how viscosity affects flow rates, suggesting that while the formula holds for low-viscosity fluids, it may not apply to highly viscous substances like honey or pitch. The implications of viscosity on flow dynamics challenge the classical equations used for simpler fluids. Overall, the discussion highlights the need for modifications to flow equations when dealing with non-Newtonian fluids.
vorcil
Messages
395
Reaction score
0
Imagine a hollow cylinder filled with water (a water tank)
a hole is near the bottom of the cylinder

the hole is covered, the tank filled with water and then the hole is uncovered

the volume flow rate = Q
h = the height of the hole from the water level

Q = Pi*r^2 * (squareroot 2gh)
(i solved this from)

q=av (area * velocity)

area of cylinder = pi R^2

velocity as it leave the hole = Squareroot (2gh) -> (h being the height from the hole to the water level)


after doing the experiment and graphs and stuff i got the velocity of the water jet to be 2.816 ms^-1

question:
would the velocity be different if i had mercury in the cylinder instead of water?

i know the velocity is determined by \sqrt{}(2gh)
so the density and mass of the liquid shouldn't make a difference!

but that made me think, what if i put something like honey or treacle into the cylinder.
it would definitely be slower, So wouldn't \sqrt{}(2gh) be wrong? even though my textbook says to use that formula?
 
Physics news on Phys.org
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Trying to understand the logic behind adding vectors with an angle between them'
My initial calculation was to subtract V1 from V2 to show that from the perspective of the second aircraft the first one is -300km/h. So i checked with ChatGPT and it said I cant just subtract them because I have an angle between them. So I dont understand the reasoning of it. Like why should a velocity be dependent on an angle? I was thinking about how it would look like if the planes where parallel to each other, and then how it look like if one is turning away and I dont see it. Since...
Back
Top