Have you read 'Circuit Simulation' by Farid Najm?

AI Thread Summary
The discussion centers on the book "Circuit Simulation" by Farid Najm, which is praised for its insights into DC and transient analysis in circuit simulation. The original poster, a Brazilian electrical engineering student, seeks to connect with others who have read the book or have experience in circuit simulation development. They also mention another influential book by Leon Chua on computer-aided analysis of electronic circuits, highlighting a lack of additional resources on the topic. The conversation aims to foster sharing of experiences and knowledge related to circuit simulation literature. Engaging with these texts can enhance understanding and innovation in circuit simulator development.
rockerman
Messages
13
Reaction score
0
Hello everyone! I'm a brazilian electrical engineer student and enthusiastic on development of circuit simulators, with a approach on the DC-analysis and Transient analysis. now I'm using one book released this year by "wiley and sons", it is a very good one, called "Circuit simulation - Farid Najm" ... i would like to share experiences about that book and about that theme and know if someone already done something like that?

thx
 
Engineering news on Phys.org
exists other book, whose writer is mrs. Leon Chua (the father of memristor), called "Computer-Aided Analysis of Electronic Circuits: Algorithms and Computational Techniques", released on 1975, which is another very good one.Beyond this two books cited below, i didn't find another books about it.
 
where is "below" interpret as "above" ^^
 
Very basic question. Consider a 3-terminal device with terminals say A,B,C. Kirchhoff Current Law (KCL) and Kirchhoff Voltage Law (KVL) establish two relationships between the 3 currents entering the terminals and the 3 terminal's voltage pairs respectively. So we have 2 equations in 6 unknowns. To proceed further we need two more (independent) equations in order to solve the circuit the 3-terminal device is connected to (basically one treats such a device as an unbalanced two-port...
suppose you have two capacitors with a 0.1 Farad value and 12 VDC rating. label these as A and B. label the terminals of each as 1 and 2. you also have a voltmeter with a 40 volt linear range for DC. you also have a 9 volt DC power supply fed by mains. you charge each capacitor to 9 volts with terminal 1 being - (negative) and terminal 2 being + (positive). you connect the voltmeter to terminal A2 and to terminal B1. does it read any voltage? can - of one capacitor discharge + of the...
Thread 'Weird near-field phenomenon I get in my EM simulation'
I recently made a basic simulation of wire antennas and I am not sure if the near field in my simulation is modeled correctly. One of the things that worry me is the fact that sometimes I see in my simulation "movements" in the near field that seems to be faster than the speed of wave propagation I defined (the speed of light in the simulation). Specifically I see "nodes" of low amplitude in the E field that are quickly "emitted" from the antenna and then slow down as they approach the far...
Back
Top