Help me in design gearbox problem for milling machine

  • Thread starter Thread starter hellovn
  • Start date Start date
  • Tags Tags
    Design Machine
AI Thread Summary
Key input data for designing a gearbox for a milling machine using Finite Element Method (FEM) includes cutting force, spindle speed, and load torsion moment, as these factors significantly influence the gearbox structure. Understanding these parameters is crucial for accurate simulations and structural analysis. The discussion emphasizes the importance of selecting appropriate data for effective FEM calculations. Additionally, users are reminded to avoid double-posting in forums. Accurate input data is essential for optimizing gearbox design and performance.
hellovn
Messages
6
Reaction score
0
hello alll
I am designing a gearbox for milling machine. For Finite element Method purpose, what are the input data (such as cutting force, spindle speed or load torsion moment) most influencing to structure of the gearbox? I am using FEM software for calculating the structure of this gearbox
 
Engineering news on Phys.org
Welcome to PF, Hellovn.
Please don't double-post. Your other posting of this in Systems and Design has already attracted a response.
 

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
View full post »
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
View full post »

Similar threads

Gearbox with single input, double output (at different RPM)
Replies
10
Views
2K
I in designing a single speed reduction gearbox
Replies
11
Views
3K
Spindle gearbox: milling machine tool speed changer
Replies
2
Views
4K
Wind-Turbine Gearbox Design project
Replies
2
Views
7K
FEM for Gearbox Design: Key Input Data for Finite Element Method Analysis
Replies
10
Views
7K
Design Shear Pin for Gate Valve at 763 N.m Torque
Replies
11
Views
17K
Help needed to solve a static analysis for the design of the Shaft for a Grinding Machine
Replies
4
Views
1K
Automotive Vehicle and Engine Simulink Model Engine rpm calculation
Replies
2
Views
3K
Design, Manufacture and Machining of Carbon composites for RC planes
Replies
3
Views
2K
Automotive Parameters required for a ZK worm gear
Replies
9
Views
3K

Hot Threads

Recent Insights

Back
Top