Automotive How Do You Calculate the Flow Rate for a Diesel Engine Oil Pump?

AI Thread Summary
To calculate the flow rate for a diesel engine oil pump, it is essential to consider both the nominal and maximum clearances of the pump components. The flow rate requirement can be determined by analyzing the engine's lubrication needs, which depend on factors such as engine size and operating conditions. A common approach involves using the formula that incorporates the pump's displacement and speed. Additionally, understanding the viscosity of the oil at operating temperatures is crucial for accurate calculations. Proper flow rate ensures optimal engine performance and longevity.
malodeatul
Messages
5
Reaction score
0
Hello Gentlemen, Do you help me in finding flow rate calculation for diesel engine oil pump?
Is anyone know procedure need follow based nominal clearance / maximum clearance?
How we can find flow rate requirement for engine.
 
Engineering news on Phys.org
Hello Gentlemen, Do you help me in finding flow rate calculation for diesel engine oil pump?
 

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
View full post »
Thread 'What's the most likely cause for this carbon seal crack?'

Thread 'What's the most likely cause for this carbon seal crack?'

We have a molded carbon graphite seal that is used in an inline axial piston, variable displacement hydraulic pump. One of our customers reported that, when using the “A” parts in the past, they only needed to replace them due to normal wear. However, after switching to our parts, the replacement cycle seems to be much shorter due to “broken” or “cracked” failures. This issue was identified after hydraulic fluid leakage was observed. According to their records, the same problem has occurred...
View full post »

Similar threads

How does a pump trade head for flow rate?
Replies
3
Views
3K
Flow rate needed to lift object inside a vertical pipe
Replies
4
Views
2K
How to determine air velocity in open ended tube?
Replies
9
Views
2K
How to calculate effective pump flow-rate across a filter?
Replies
2
Views
4K
Calculating Output Pressure for 15L N2/min
Replies
15
Views
3K
Exit flow rate in a Plate Heat Exchanger
Replies
4
Views
3K
Calculating Fluid Flow: Help with Q, A1, A2, Delta h, g & C
Replies
2
Views
2K
How to determine the pressure drop in pipe diameter sizing
Replies
5
Views
2K
How do we model water flow problems?
Replies
14
Views
2K
Automotive How long does engine oil really stay good?
Replies
12
Views
2K

Hot Threads

Recent Insights

Back
Top