- #1
Heals
- 1
- 0
I have a load cell which must be placed onto a piece of vehicle structure. In an ideal world I would attach the load cell to the structure and calibrate both together to ensure a very accurate calibration, and that accurate loads are measured. However a problem arises if I need to replace the load cell (i.e. due to failure), as it is impractical to calibrate the new load cell and structure together once installed on the vehicle, instead I would like to replace just the load cell. Is it possible to 'calibrate' a piece of vehicle structure so that when I attach a new calibrated load cell, I can combine the structure’s calibration data with that of the new load cell’s to obtain accurate loads?