On non linear resistor and how to calculate a fixed resistor.

  • Thread starter Thread starter physikamateur
  • Start date Start date
  • Tags Tags
    Linear Resistor
AI Thread Summary
The current through a non-linear resistor is defined by the equation I=0.05V^3, with a series connection to a fixed resistor and a 9V voltage source. To achieve a current of 0.40A, the voltage drop across the non-linear resistor is calculated to be 2V, resulting in a 7V drop across the fixed resistor. Using Ohm's law, the required resistance for the fixed resistor is determined to be 17.5 ohms. The calculations confirm that the approach to solving the problem is correct. The solution effectively integrates the non-linear characteristics of the resistor with standard circuit analysis.
physikamateur
Messages
12
Reaction score
0

Homework Statement



The current in amperes through a certain type of non-linear resistor is given by I=0.05V^3, where V is the potential difference in volts across the resistor. This resistor is connected in series to a fixed resistor and a constant voltage source of 9V is connected across the series combination. What value of resistance should the fixed resistor have so that a current of 0.40A flows ?

Homework Equations


V=IR and P=VI ?



The Attempt at a Solution


I first tried to calculate the total resistance which gives 22.5 ohms. But I do not know how to calculate the non-linear resistor as it does not obey ohm's law hence no proper formula can be used ? Please help.

Thank you.

 
Physics news on Phys.org
Suppose that, as stated, a current of 0.40A is flowing through the nonlinear resistor. What will be the voltage drop across it according to the given formula for it (you may have to rearrange the formula)?
 
By I=0.05V^3, when I=0.40A, V=2V. Hence voltage drop across the fixed resistor is 9-2=7V.
Therefore by V=IR, 7=0.4R,
Therefore R=17.5 ohms

Am I right ?
 
Looks good!
 
Thanks a lot !
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Trying to understand the logic behind adding vectors with an angle between them'
My initial calculation was to subtract V1 from V2 to show that from the perspective of the second aircraft the first one is -300km/h. So i checked with ChatGPT and it said I cant just subtract them because I have an angle between them. So I dont understand the reasoning of it. Like why should a velocity be dependent on an angle? I was thinking about how it would look like if the planes where parallel to each other, and then how it look like if one is turning away and I dont see it. Since...
Back
Top