Projectile Motion of Diver Problem

AI Thread Summary
A diver with a vertical velocity of 5.7 m/s, horizontal velocity of 1.2 m/s, and a height of 3.49 m will take approximately 1.16 seconds to return to the same height. The horizontal range covered during this time is calculated to be 1.4 meters. The correct approach involves using the formula for vertical motion, s = ut + 1/2gt^2, to determine time and the horizontal range as Range = (Vhor)(Time). The discussion confirms that the initial calculations provided are accurate. The problem emphasizes the application of 2D motion equations in projectile motion scenarios.
stuart_5
Messages
3
Reaction score
0
A diver leaves the springboard with a vertical velocity of 5.7m/s, and horizontal velocity of 1.2 m/s, and a height of 3.49m. How long will it take her to return to the same height? What horizontal range will she cover in this time?

Would I use: Time = 2Vvert/g for the first part? And Range = (Vhor)(Time) for the second part?
MY ANSWERS:
1st part --> Time = 1.16 s
2nd part --> Range = 1.4 m

Is this correct? :confused:
 
Physics news on Phys.org
In order to solve this qn, perphaps using the formulae for 2D motion will be the easiest.

Since time is the quantity tat u r finding..of course it must be in ur formula.. Given the height to be the 3.49m... for the diver to reach back the same displacement later in the dive, u will need to use the formula s=ut+1/2gt^2 to solve.. the formula for quadratic eqns will get u 2 values for t.. the ans will be the later t.
 
oh ya.. for the previous post, initial velocity, u, is the initial vertical velocity..

For the 2nd part.. assuming zero air resistance, the horizontal velocity the diver travels will be the initial horizontal velocity times the time u found in (a)
 
In this case s=0 so the t cancels out and you get the equation
t = 2Vy/g. No need to solve quadratic equations.
 
Projectile Motion Q...cont.

daniel_i_l: So my work that is shown in my initial post is correct then?
 
yes, it is
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top