Remove a force, what would be the resultant

  • Thread starter Thread starter ammoun
  • Start date Start date
  • Tags Tags
    Force Resultant
AI Thread Summary
When the 1000N force acting to the left is removed from the packing crate, the remaining forces are 300N to the right and the friction force. Since the crate is at rest, the friction force must balance the applied forces, which means it would adjust to 300N to the left to counteract the 300N force to the right. Therefore, the resultant force acting on the crate is zero. The reasoning presented confirms that the friction force compensates for the rightward force, leading to no net movement.
ammoun
Messages
5
Reaction score
0

Homework Statement


A packing crate rests on a horizontal surface. It is acted on by three horizontal forces: 1000N to the left, 300N to the right, and friction. The weight of the crate is 500N. If the 1000N force is removed, the resultant force acting on the block is

A) zero
B) 300 N to the left
C) 300 N to the right
D) 500 N to the left
E) impossible to determine from the information given.


The Attempt at a Solution



I would say E) since I have no info about the friction. Could you please confirm.

Thank you
 
Physics news on Phys.org
It's not brilliantly worded, but I think the clue is when it says that the 'crate *rests* on a horizontal surface'. i.e. it isn't moving. That should give you some info about the friction force.
 
Alright so when the crate is resting the friction would be 700.

If we remove the 1000 N force, the friction would be to the opposite direction and decrease to 300 to cancel the right force.

The resultant force would A) zero.

Is there any problem in this reasoning.
 
Looks fine to me!
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top