Resistor and power output varying with a distance x

AI Thread Summary
The discussion revolves around calculating the power dissipated in a resistor as a function of the distance x, with a battery connected across a uniform resistor. Participants express confusion about how to approach the problem, particularly regarding the arrangement of resistors and how to calculate total resistance as x varies. The equations for power and resistance in parallel are referenced, but clarity on the specific configuration is lacking. There is a request for further explanation and assistance in visualizing the circuit setup. The conversation highlights the need for a better understanding of resistor configurations and their impact on power dissipation.
Jonnyto
Messages
12
Reaction score
0

Homework Statement


Figure 29 shows a battery connected across a uniform resistor R0. A sliding contact can move across the resistor from x=0 at the left to x=10 cm at the right. Find an expression for the power dissipated in the resistor R as a function of x. Plot the function for ℰ=50 V, R=2000Ω , and R0=100Ω


Homework Equations


P=\frac{V<sup>2</sup>}{R}



The Attempt at a Solution


I have no clue at all on how to solve this problem. I think that it might have to do with how resistors are adding up in parallel. I really can't see which one is in parallel. I don't see how to determine the resistance with the varying x.

fig29.JPG
 
Physics news on Phys.org
This circuit is equivalent to three resistors: Rl, Rr, and R. Rl and Rr are the left and right, correspondingly, parts of Ro; their values depend on x. Solve for voltage at R and current through it.
 
It's helpful to post a full size image if it's not too large.

attachment.php?attachmentid=58418&d=1367488623.jpg
 
may be this be help..
R_{total}=(R // R_{p}) + R_{s})
upload1.JPG


just as Voko said #2
 
Complex

arifz2303 said:
may be this be help..
r_{total}=(r // r_{p}) + r_{s})




just as voko said #2

please explain more about the problem
 
Last edited by a moderator:
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
Thread 'Trying to understand the logic behind adding vectors with an angle between them'
My initial calculation was to subtract V1 from V2 to show that from the perspective of the second aircraft the first one is -300km/h. So i checked with ChatGPT and it said I cant just subtract them because I have an angle between them. So I dont understand the reasoning of it. Like why should a velocity be dependent on an angle? I was thinking about how it would look like if the planes where parallel to each other, and then how it look like if one is turning away and I dont see it. Since...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top