Solve Spring Frequency Homework: .88kg to .4kg

  • Thread starter Thread starter jdeakons
  • Start date Start date
  • Tags Tags
    Frequency Spring
AI Thread Summary
To solve the problem of finding the new frequency of a spring when the mass is decreased from 0.88 kg to 0.4 kg, the relevant equation is f = (1/2π)√(k/m). The original frequency is 1.8 Hz with a mass of 0.88 kg, leading to the calculation of spring constant k as 112.56 N/m. When the mass is reduced to 0.4 kg, the new frequency can be calculated using the same spring constant. The confusion arises from the different methods used to derive k, but they should yield consistent results. The final frequency for the 0.4 kg mass is approximately 2.7 Hz.
jdeakons
Messages
3
Reaction score
0

Homework Statement


A mass of .88 kg when fastened to the lower end of a light-weight spring and set vibrating up and down is found to have a frequency of 1.8 Hz. Calculate the new frequency of vibration when the mass is decreased to .4 kg.

Homework Equations


P = 2 \pi \sqrt{m/k}

The Attempt at a Solution


Using K = (m 4 \pi^2 ) / P^2, my answer for K comes out to 112.56.

But, using \sqrt{k} = (\sqrt{m} 2 \pi )/ P, I get 3.2572. But how can that be? The equations are the same, aren't they? Where am I making the mistake?

Thanks.
 
Physics news on Phys.org
2\pi f=\sqrt{\frac{k}{m}}
 
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Trying to understand the logic behind adding vectors with an angle between them'
My initial calculation was to subtract V1 from V2 to show that from the perspective of the second aircraft the first one is -300km/h. So i checked with ChatGPT and it said I cant just subtract them because I have an angle between them. So I dont understand the reasoning of it. Like why should a velocity be dependent on an angle? I was thinking about how it would look like if the planes where parallel to each other, and then how it look like if one is turning away and I dont see it. Since...
Back
Top