What does "[Ar]" Symbolize in Chemistry?

  • Thread starter Thread starter Masschaos
  • Start date Start date
  • Tags Tags
    Chemistry
AI Thread Summary
The symbol '[Ar]' represents the electron configuration of Argon, which is used as shorthand to simplify the notation of electron configurations in chemistry. Instead of detailing the full configuration of inner shell electrons, chemists use '[Ar]' to indicate the completed electron shells of Argon (1s2 2s2 2p6 3s2 3p6). This shorthand is commonly applied in questions regarding ground state electronic configurations, making it easier to identify and analyze the outer shell electrons of elements like Calcium and Zinc.
Masschaos
Messages
30
Reaction score
0
I've been going through some chemistry revision for my exams, and I've been noticing this symbol '[Ar]' pop up a lot. At first I thought it was the concentration of Argon atoms, but that doesn't make sense. It appears in some question in the following way.

Which ground state electronic configurations are incorrect?

a) Ca: [Ar] 4s2
b) Zn: [Ar] 2d10 4s2
and so on.
What does it mean?
 
Chemistry news on Phys.org
It's short-hand for the electron configuration of Argon (1s2 2s2 2p6 3s2 3p6). Instead of writing out the configuration of the inner shell electrons, chemists usually shorten it by writing [Ar] instead.
 
Ygggdrasil said:
hemists usually shorten it by writing [Ar] instead.

Or whatever other noble gas is applicable.
 
Ahh! Thanks!
 
I want to test a humidity sensor with one or more saturated salt solutions. The table salt that I have on hand contains one of two anticaking agents, calcium silicate or sodium aluminosilicate. Will the presence of either of these additives (or iodine for that matter) significantly affect the equilibrium humidity? I searched and all the how-to-do-it guides did not address this question. One research paper I found reported that at 1.5% w/w calcium silicate increased the deliquescent point by...
I'm trying to find a cheap DIY method to etch holes of various shapes through 0.3mm Aluminium sheet using 5-10% Sodium Hydroxide. The idea is to apply a resist to the Aluminium then selectively ablate it off using a diode laser cutter and then dissolve away the Aluminium using Sodium Hydroxide. By cheap I mean resists costing say £20 in small quantities. The Internet has suggested various resists to try including... Enamel paint (only survived seconds in the NaOH!) Acrylic paint (only...
Back
Top