Which material has the greatest Young's Modulus?

AI Thread Summary
The discussion centers on determining which graph represents the material with the greatest Young's Modulus. The initial conclusion was that graph B has the highest slope in its linear portion, suggesting it should be correct. However, the answer key indicates graph A is correct, leading to confusion about whether the entire graph or just the linear portion should be considered. Clarification from a source indicates that Young's Modulus is defined by the slope of the elastic portion of the curve, supporting the choice of graph B. This highlights the importance of focusing on the elastic region when calculating Young's Modulus.
songoku
Messages
2,476
Reaction score
391
Homework Statement
Please see below
Relevant Equations
Young Modulus = stress / strain
1695226104886.png


My answer is (B) since it has the highest slope for the straight line part of the graph but the answer key is (A). Is it because the slope of graph B will decrease until the value less than slope A? So we don't only consider the straight line part but the whole graph?

Thanks
 
Physics news on Phys.org
songoku said:
Homework Statement: Please see below
Relevant Equations: Young Modulus = stress / strain

View attachment 332269

My answer is (B) since it has the highest slope for the straight line part of the graph but the answer key is (A). Is it because the slope of graph B will decrease until the value less than slope A? So we don't only consider the straight line part but the whole graph?

Thanks
According to https://en.wikipedia.org/wiki/Young's_modulus, it is the slope of the elastic portion (the linear part at the start) of the curve. That makes B correct.
 
Reply
  • Like
Likes erobz and songoku
Thank you very much haruspex
 

Thread 'Rolling without slipping on a curved surface'

Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
View full post »

Thread 'Struggling to understand the concept of this question (ice cube in water optics question)'

TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
View full post »

Similar threads

Confusion Calculating Young's Modulus
Replies
5
Views
2K
Comparing slopes and accelerations in a graph
Replies
5
Views
1K
Rating speeds from least to greatest from a position time graph
Replies
1
Views
1K
Finding Young's Modulus for Steel from two graphs
Replies
1
Views
4K
B Why is Young's modulus constant below the limit of proportionality?
Replies
23
Views
4K
Calculating Bulk and Shear Modulus with Young's Modulus and Poisson's Ratio
Replies
2
Views
3K
Experimental Design: Pulley and Mass Hangers
Replies
30
Views
3K
Question Concerning The Coefficient of Friction: Block on a Rough Inclined Plane
Replies
5
Views
2K
A cylinder of snow rolls down a hill gathering more snow -- calculate its speed
Replies
39
Views
3K
The physical meaning of a slope
Replies
15
Views
12K

Hot Threads

Recent Insights

Back
Top