Quality Factor of Oscillator, Can someone Look at My Work Please

AI Thread Summary
The discussion revolves around the calculation of the quality factor of an oscillator, specifically regarding the energy radiated by an accelerated electron. The user initially finds the energy radiated over one cycle correctly, but encounters a discrepancy in the quality factor calculation, where their result includes a factor of 2 instead of the expected 4. They derive the energy stored and dissipated per cycle but are unsure where their calculations diverge from the answer key. The user mentions using an approximation for small values, which may influence the outcome. Clarification is sought on the calculations to identify the source of the factor discrepancy.
mmmboh
Messages
401
Reaction score
0
Hi, so I did the question, but apparently my answer is off by a factor of 2.

An accelerated electron radiates energy at the rate Ke2a2/c3...e is the electron charge, a is the instantaneous acceleration, c is the speed of light, K=6x109Nm2/C2...whatever that is.

So first I had to find how much energy an electron oscillating in a straight line would radiate over one cycle, the motion is describe by x=Asin(2\pift), I did that and according to the answer book I am right, it is Ke28A2pi4f3/c3.

For the next part I have to find the quality factor...I know that is 2\pi x energy stored/energy dissipated per cycle, and the energy stored is 1/2 kA2, and since k=w0m the energy stored becomes (1/2)4pi2f2mA2...when I do that times 2\pi, and then divide that by the energy dissipated over one cycle that I found in the first part, I get as an answer mc3/(2Ke2pif)...but according to the answer book the denominator should be multiplied by a factor of 4, not two...

Am I missing something here? I can't figure out where my mistake is..
 
Last edited:
Physics news on Phys.org
can anyone clear this up please?
 
I am getting same results as you
factor of 2 , not 4.
I used the aproximation of ln(1-x)=-x if x<1 assuming the radiation is not taking too much energy of the electron
 
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Thread 'Variable mass system : water sprayed into a moving container'
Starting with the mass considerations #m(t)# is mass of water #M_{c}# mass of container and #M(t)# mass of total system $$M(t) = M_{C} + m(t)$$ $$\Rightarrow \frac{dM(t)}{dt} = \frac{dm(t)}{dt}$$ $$P_i = Mv + u \, dm$$ $$P_f = (M + dm)(v + dv)$$ $$\Delta P = M \, dv + (v - u) \, dm$$ $$F = \frac{dP}{dt} = M \frac{dv}{dt} + (v - u) \frac{dm}{dt}$$ $$F = u \frac{dm}{dt} = \rho A u^2$$ from conservation of momentum , the cannon recoils with the same force which it applies. $$\quad \frac{dm}{dt}...
Back
Top