Why cosine wave for phase deviation in phase modulation?

AI Thread Summary
Phase modulation maintains a constant amplitude of the carrier while varying its phase based on the modulating signal. The phase deviation is proportional to the instantaneous amplitude of the modulating voltage, with the rate of change corresponding to the modulating frequency. The discussion highlights confusion regarding the use of a cosine wave for phase deviation when the modulating signal is a sine wave. It suggests that the cosine may be preferred in vector rotation analysis, where the real component is cosine and the imaginary component is sine. Clarification is needed through visual aids, as the absence of figures complicates the understanding of the phase relationship.
asitiaf
Messages
21
Reaction score
0
Phase modulation is a system in which the amplitude of the modulated carrier is kept constant, while its phase and rate of phase change are varied by the modulating signal.
By the definition of phase modulation, the amount by which the carrier phase is varied from its unmodulated value, called the phase deviation, is made proportional to the instantaneous amplitude of the modulating voltage.
The rate at which this phase variation changes is equal oy the modulating frequency.
But in the book, i see that modulating signal is a sine wave, but the curve for phase deviation is cosine wave. Why?
 
Engineering news on Phys.org
asitiaf said:
Phase modulation is a system in which the amplitude of the modulated carrier is kept constant, while its phase and rate of phase change are varied by the modulating signal.
By the definition of phase modulation, the amount by which the carrier phase is varied from its unmodulated value, called the phase deviation, is made proportional to the instantaneous amplitude of the modulating voltage.
The rate at which this phase variation changes is equal oy the modulating frequency.
But in the book, i see that modulating signal is a sine wave, but the curve for phase deviation is cosine wave. Why?

Could you upload scans of these figures? That would make it easier for us to explain what is going on...
 
I don't see how a 90 degree phase shift would be introduced. If the modulating voltage is zero, and it is really phase modulation, then the phase deviation would be zero unless there is some shift introduced that you are not mentioning. Maybe it is frequency modulation?
 
When modulation is analysed as a vector rotation, the real component is the cosine while the imaginary component is the sine of the modulation angle. This may be why it is more natural to employ the cosine than the sine in the analysis of the modulation.
 
If book is showing phase modulation using VCO, the tuning voltage (which is in phase with freq) will be 90 degree shifted from phase (integral of frequency).

This is speculation though since OP has not posted the figures.
 
Last edited:
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
Back
Top