How Can I Connect a 36-Pin Wiring Black Box Without a Diagram?

AI Thread Summary
Connecting a 36-pin wiring black box without a diagram can be challenging, but creating a wiring diagram by tracing the circuit is a viable option. The device is designed primarily for activating solenoids. A user managed to contact the manufacturer, who provided the necessary diagrams for proper connection. This highlights the importance of reaching out to the original creator for assistance. Overall, while it may require some effort, solutions are available for those needing to connect the device.
Wetmelon
Messages
154
Reaction score
1
I know what this is SUPPOSED to do, but I have no diagram to show me how to hook up the *counts* 36 pins. Image attached.

Is there any hope for me, doc?
 

Attachments

  • 100_1668.jpg
    100_1668.jpg
    85.8 KB · Views: 463
Engineering news on Phys.org
What is it supposed to do?

You might have to open up mutlisim and just make the wiring diagram your self by tracing through the circuit. You can also do it by hand.
 
It's supposed to do a lot of stuff, mainly activating solenoids. But I finally got a hold of the guy who made it and he had the diagrams:
 

Attachments

Thread 'What happens if shielded cable has a short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Similar threads

How to make an Electrical Diagram with added Steinmetz Circuit for a Delta 3 phase motor?
Replies
0
Views
2K
Why Does the Filament Box in a CRT Electron Gun Have Multiple Pins?
Replies
12
Views
2K
Request a Diagram or Explanation to wire 220v-50/60hz UK 3-wire device
Replies
1
Views
2K
How can I reroute multiple signals from a 4 pin connector using a relay switch?
Replies
37
Views
6K
Charlieplexing: LEDs have different brightness
Replies
14
Views
2K
Schematic capture / wiring diagram software
Replies
18
Views
2K
What happens when 12V and GND are both connected to the GND pin?
Replies
12
Views
5K
How Can I Waterproof a Soldered Wire Connection?
Replies
4
Views
2K
Protecting My Condenser From Surge: Installing a Surge Protector
Replies
25
Views
3K
Finding transformer's wire wrapping direction without taking it apart.
Replies
3
Views
1K

Hot Threads

Recent Insights

Back
Top