Average velocity vs Final velocity

AI Thread Summary
Average velocity multiplied by two does not always equal final velocity, particularly in cases of non-uniform acceleration. In this discussion, the experiment involved a volleyball dropped in free fall, where average velocity was calculated as 3.55 m/s, leading to a doubled value of 7.1 m/s. However, using the equation vf = gt provided a final velocity of 5.29 m/s, highlighting discrepancies likely due to experimental error. The relationship between average and final velocity holds true under specific conditions, such as constant acceleration from rest. Overall, the significant difference in results emphasizes the importance of accurate measurements in physics experiments.
BernieCooke
Messages
5
Reaction score
0

Homework Statement



Shouldn't average velocity multiplied by 2 be equal to final velocity. We were doing a lab and we calculated an average time of .54 seconds to travel 1.92 meters. Multiplying the average velocity by 2 gives an extremely different answer than vf=gt. I know there is probably some experimental error, but I would think it would be 2-3m/s off. Any help?

Homework Equations





The Attempt at a Solution

 
Physics news on Phys.org
For uniformly accelerated motion starting from rest, the average velocity will be half of the final velocity. Is that the situation?
 
First of all, the final velocity is not generally the average velocity times 2. Imagine that the your object were to go from zero to 1 m/s really quickly, and then traveled at 1 m/s for the rest of the trip (if you think this is unrealistic, think of a scrap of paper dropped in the air- it gets up to its final speed quickly and stays there through the rest of the fall). Then the average velocity and the final velocity would both be close to 1 m/s.

For your case, I'm assuming you're using something much denser than a piece of paper, and since you're using the equation vf=gt you're probably dealing with something dropped into a short free fall. In that case, just using vf=gt should give you something pretty close to the actual final velocity.
 
Oh, and I forgot to mention, the final velocity is twice the average velocity in the special case that the object starts from rest and accelerates at constant velocity. If these conditions are met, then the final velocity is vf=a*T, the total distance is (1/2)a*T\stackrel{2}{}, and the average velocity is va=(1/2)a*T\stackrel{2}{}/T=(1/2)a*T; so vf=2va (T denotes total travel time).

So once again, assuming that your lab is a drop from free fall, the acceleration is close to constant "g" for a short fall, and the final velocity should be relatively close to twice the average.
 
You are correct, it was freefall using a volleyball. Sorry, I should have included that information. I am assuming the numbers were so off due to experimental error with the timing. Thanks so much for your help.
 
The way it turns out 1.92m/0.54s = 3.55m/s, multiply that by 2 and you get 7.1m/s. If you set vf = gt then it is 9.8 x .54 which results in 5.29m/s. This difference just seemed so large to me, but the first equation assumes everything is done very accurately, while the second equation does not really care what distance was traveled in that time. It assumes the distance traveled was 1.42m given h=1/2gt2.
 
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Thread 'Variable mass system : water sprayed into a moving container'
Starting with the mass considerations #m(t)# is mass of water #M_{c}# mass of container and #M(t)# mass of total system $$M(t) = M_{C} + m(t)$$ $$\Rightarrow \frac{dM(t)}{dt} = \frac{dm(t)}{dt}$$ $$P_i = Mv + u \, dm$$ $$P_f = (M + dm)(v + dv)$$ $$\Delta P = M \, dv + (v - u) \, dm$$ $$F = \frac{dP}{dt} = M \frac{dv}{dt} + (v - u) \frac{dm}{dt}$$ $$F = u \frac{dm}{dt} = \rho A u^2$$ from conservation of momentum , the cannon recoils with the same force which it applies. $$\quad \frac{dm}{dt}...
Back
Top