Calculating Head Loss from Enlargement in Compressible Fluid

AI Thread Summary
Calculating head loss due to sudden enlargement in compressible fluids can be complex. A recommended resource for understanding this topic is Crane's TP 410, which provides valuable insights. Users are encouraged to utilize the forum's search function to find previous discussions and additional resources on the subject. For practical calculations, specific links to relevant tools and references are available. Understanding these principles is essential for accurate fluid dynamics analysis.
johnmane
Messages
5
Reaction score
0
how to calculate head loss due to sudden enlargement in case of compressible fluid?

hiiiiii guys, am graduate student, i want to know @ head loss in case of compressible fluid due to sudden enlargement...pls help me ...as soon as possible...
 
Engineering news on Phys.org


johnmane said:
hiiiiii guys, am graduate student, i want to know @ head loss in case of compressible fluid due to sudden enlargement...pls help me ...as soon as possible...

What do you want to know about it?

CS
 

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
View full post »
Thread 'What's the most likely cause for this carbon seal crack?'

Thread 'What's the most likely cause for this carbon seal crack?'

We have a molded carbon graphite seal that is used in an inline axial piston, variable displacement hydraulic pump. One of our customers reported that, when using the “A” parts in the past, they only needed to replace them due to normal wear. However, after switching to our parts, the replacement cycle seems to be much shorter due to “broken” or “cracked” failures. This issue was identified after hydraulic fluid leakage was observed. According to their records, the same problem has occurred...
View full post »

Similar threads

Understanding energy losses in a compressed air system
Replies
3
Views
2K
Compressed air problem (pressure and flow rate calculations)
Replies
6
Views
3K
Pressure loss pipe system: Conversion from known fluid1 to fluid2
Replies
8
Views
2K
Calculating Fluid Flow: Help with Q, A1, A2, Delta h, g & C
Replies
2
Views
2K
Modeling Air Compression Cylinder
Replies
45
Views
5K
Turnbuckles and loss of preload
Replies
8
Views
2K
Pneumatic Air Tools - Hose / Compressor Friction Loss?
Replies
3
Views
491
Lubrication in fasteners and loss of preload
Replies
18
Views
2K
Compressed air pressure vs hydrostatic pressure
Replies
8
Views
3K
PHES model (pumped hydro energy storage)
Replies
2
Views
2K

Hot Threads

Recent Insights

Back
Top