Find μk between the block and the inclined plane?

AI Thread Summary
To find the coefficient of kinetic friction (μk) between a block and an inclined plane, one can set up equations using the block's acceleration of 3.5 m/s² and the angle of inclination at 27.0°. The mass of the block is not needed as it cancels out in the equations. It is recommended to express all terms in variables before performing numerical calculations. Engaging with the community for guidance can help clarify any confusion in the process.
HebrewHammer
Messages
8
Reaction score
0
A block accelerates 3.5 m/s2 down a plane
inclined at angle 27.0◦.
The acceleration of gravity is 9.81 m/s2 .
Find μk between the block and the inclined
plane.

I am completely lost. How can I find the μk if I do not know the mass of the block?
 
Physics news on Phys.org
The mass term should cancel out of your equations. Try leaving everything in terms of the variables, and save the numerical calculations until the very end.
 
Do you know the 2 forumals used?
 
Welcome to PF!

HebrewHammer said:
I am completely lost. How can I find the μk if I do not know the mass of the block?

Hi HebrewHammer! Welcome to PF! :smile:

As hage567 suggests, call the mass "m", and then do all the equations as usual. :wink:

If you get stuck, show us how far you've got, and then we can see what the problem is. :smile:
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top