How Big of a Motor Do I Need to Move a 12t Cart on Rails at 5m/min?

  • Thread starter Thread starter Inenzo
  • Start date Start date
  • Tags Tags
    Cart Static
AI Thread Summary
To calculate the motor size needed to move a 12-ton cart on rails at 5 meters per minute, key factors include the gearbox ratio, wheel size, and incline of the surface. The cart has a flat surface and uses wheels measuring 230mm. The total mass is confirmed to be 12 tons, which is the maximum load. Determining the gearbox ratio is essential for calculating the maximum torque required from the motor. Accurate specifications will enable a more precise motor size calculation.
Inenzo
Messages
2
Reaction score
0
Need to calculate motor size to drive skip dolley system. have the following:
Frame on 6 wheels. Gearbox/motor driving middle pair of wheels.
Total mass 12t
Need to move trolley @ 5m/min

Any thoughts where to begin?
 
Physics news on Phys.org
Well I'll take a stab at it,

whats the ratio on your gearbox?

size of wheels?

is the trolley for use on a flat surface or how steep are the biggest inclines?

What sort of load will it be carrying? is 12t the maximum load or just the weight empty?

Once you know those, I think we can figure out the maximum torque needed from your motor.
 
Wheels = 230mm
flat surface
max load = 12t
ratio on gearbox=? Don't know the ration since we need to source it still...
 

Thread 'Is calling fictitious forces "not real" just about terminology?'

Hi there, im studying nanoscience at the university in Basel. Today I looked at the topic of intertial and non-inertial reference frames and the existence of fictitious forces. I understand that you call forces real in physics if they appear in interplay. Meaning that a force is real when there is the "actio" partner to the "reactio" partner. If this condition is not satisfied the force is not real. I also understand that if you specifically look at non-inertial reference frames you can...
View full post »

Thread 'Derivation of Hamilton's Principle: Questions'

I have recently been really interested in the derivation of Hamiltons Principle. On my research I found that with the term ##m \cdot \frac{d}{dt} (\frac{dr}{dt} \cdot \delta r) = 0## (1) one may derivate ##\delta \int (T - V) dt = 0## (2). The derivation itself I understood quiet good, but what I don't understand is where the equation (1) came from, because in my research it was just given and not derived from anywhere. Does anybody know where (1) comes from or why from it the...
View full post »

Similar threads

Power needed to move a vehicle against inertia
Replies
10
Views
3K
How do I calculate the RPM needed to power my system?
Replies
2
Views
2K
How do I select the right motor and gear ratio for a mid-drive e-Bike?
Replies
2
Views
4K
How Much Energy Is Needed to Move and Rotate a Weighted Tray Using Rubber Tires?
Replies
3
Views
2K
Calculating Torque and RPM for Moving a Drawer with a Tiny Motor
Replies
6
Views
2K
Engineering The torque of motor required to start a car moving.
Replies
1
Views
5K
Torque specs for 6,000lb party bike
Replies
7
Views
3K
How do I size a hydraulic motor to fit a 12 propeller to move water?
Replies
3
Views
3K
How can I add an end switch to carraige system
Replies
2
Views
2K
What kind of motor do you think i need?
Replies
3
Views
2K

Hot Threads

Recent Insights

Back
Top