Power Calculation for Mechanical Component Drives

AI Thread Summary
To determine motor capacity for mechanical component drives, users are seeking reliable calculation resources and reference books. A recommended resource is the downloadable Small Motor Handbook available at Bodine Electric's website. The discussion highlights the difficulty in finding detailed information in existing literature, specifically mentioning Shigley's general mechanical design books. Participants are encouraged to share additional resources or references that could assist in these calculations. Accessing the suggested handbook could provide a solid foundation for understanding motor capacities.
Analysis
Messages
52
Reaction score
0
Dear all

I need to fix motor capacity for general mechanical components drive apllications

These type of calculation sites if available pl send me the details I cannot find that ones

Any reference books pl.forward me

(I referred shigley.general mechanical design books but i can't find the details)

By
Prakash
 
Engineering news on Phys.org
Go to
www.bodine-electric.com and look for their small motor handbook. It is downloadable and will get you started.
 
TVP45 said:
Go to
www.bodine-electric.com and look for their small motor handbook. It is downloadable and will get you started.

Thanks for your reply
Let me see the site.
 

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
View full post »
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
View full post »

Similar threads

Are rectangular block springs available in market?
Replies
4
Views
1K
Automotive Poor Man's Hydrostatic drive: power steering pump as motor?
Replies
19
Views
3K
Why Is the Moment of Inertia Not Constant in Motion Control?
Replies
9
Views
1K
How to calculate required torque for a robot arm
Replies
2
Views
4K
Pumping power calculation of a vertical closed-loop system
Replies
4
Views
3K
Trying to find the torque required to turn the crankshaft in my mechanism
Replies
9
Views
3K
Automotive How Can I Calculate the Minimum Value of n2 in Tractor Power Transmission?
Replies
4
Views
2K
Calculating Power & Torque for Flywheel Drives
Replies
9
Views
2K
Supporting structures used in machines/production lines
Replies
12
Views
2K
Calculating Required Torque for 12V DC Motor
Replies
17
Views
4K

Hot Threads

Recent Insights

Back
Top