Specific Heat Problem and boiling water

AI Thread Summary
The discussion revolves around a specific heat problem involving boiling water and an aluminum pan. The user sets up the equation Q=mcΔT to calculate the final temperature after mixing 140 grams of boiling water at 100°C with an aluminum pan at 24°C. The calculations lead to a final temperature of approximately 52.319°C. Clarification is provided that this value represents the final temperature, not the temperature change. The conversation confirms the accuracy of the calculations and understanding of the concept.
clutch12
Messages
21
Reaction score
0

Homework Statement


140 grams of boiling water (temperature 100° C, heat capacity 4.2 J/gram/K) are poured into an aluminum pan whose mass is 1100 grams and initial temperature 24° C (the heat capacity of aluminum is 0.9 J/gram/K).
After a short time, what is the temperature of the water?


Homework Equations


Q=mc delta t


The Attempt at a Solution



140g(4.2J/K/gram)(T-100) = 1100g(0.9 J/K/gram)(24-T)
588T-58800 = 23760 - 990 T
588T + 990 T = 23760 + 58800
1578 T = 82560
T= 52.319

Am I doing this right?
 
Physics news on Phys.org
Looks good to me, clutch.
 
Alright and when I am determining the temperature am i subtracting 100-52.319 or no?
 
No, 52.319 is the final answer. 100-52.319 would be the change in temperature of the water.
 
oh ok thanks for clearing that up
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top