Which has the larger moment of inertia?

AI Thread Summary
The discussion centers on comparing the moment of inertia of two wheels: a uniform disk and a bicycle wheel with spokes. It concludes that the bicycle wheel has a larger moment of inertia because more of its mass is concentrated at a larger radius. This is supported by the moment of inertia formulas, where the bicycle wheel's mass distribution results in a higher value compared to the uniform disk. Participants clarify that the solid disk has more mass near the center, while the bicycle wheel's mass is primarily at the rim. Ultimately, the bicycle wheel is determined to have a greater moment of inertia.
eraemia
Messages
53
Reaction score
0

Homework Statement



Two wheels have the same total mass M and radius R. One wheel is a uniform disk. The other is like a bicycle wheel, with lightweight spokes connecting the rim to the hub. Which has the larger moment of inertia?

a. The solid disk
b. The wheel with spokes
c. There is insufficient unformation for a meaningful answer

Homework Equations





The Attempt at a Solution



the solid disk because it has less surface area / holes for air friction?
 
Physics news on Phys.org
Think about the definition of moment of inertia... it is \int{dm*r^2}
 
ok so the thin spherical shell would have a moment of inertia of 2/3 MR^2
whereas the solid sphere would have 2/5 MR^2

therefore the bicycle has more inertia
 
eraemia said:
ok so the thin spherical shell would have a moment of inertia of 2/3 MR^2
whereas the solid sphere would have 2/5 MR^2

therefore the bicycle has more inertia

Yes, exactly right. More of the mass is concentrated at a larger radius in the bicycle...

For the uniform disk, a lot of the mass is in between 0 and R... but for the bicycle most of it is located around R... so the integral dm*R^2 is higher for the bicycle.
 
alright, i think i get it now. thanks
 
I multiplied the values first without the error limit. Got 19.38. rounded it off to 2 significant figures since the given data has 2 significant figures. So = 19. For error I used the above formula. It comes out about 1.48. Now my question is. Should I write the answer as 19±1.5 (rounding 1.48 to 2 significant figures) OR should I write it as 19±1. So in short, should the error have same number of significant figures as the mean value or should it have the same number of decimal places as...
Thread 'A cylinder connected to a hanging mass'
Let's declare that for the cylinder, mass = M = 10 kg Radius = R = 4 m For the wall and the floor, Friction coeff = ##\mu## = 0.5 For the hanging mass, mass = m = 11 kg First, we divide the force according to their respective plane (x and y thing, correct me if I'm wrong) and according to which, cylinder or the hanging mass, they're working on. Force on the hanging mass $$mg - T = ma$$ Force(Cylinder) on y $$N_f + f_w - Mg = 0$$ Force(Cylinder) on x $$T + f_f - N_w = Ma$$ There's also...
Back
Top