Calculating Internal Energy Change in a Gas Under Constant Pressure

AI Thread Summary
A gas is compressed at a constant pressure of 0.639 atm from 5.41 L to 2.3 L, with 470 J of energy leaving the gas by heat. The work done on the gas was calculated as approximately 201.31 J, which was confirmed correct. However, the initial calculation for the change in internal energy (ΔU) was incorrect due to using the wrong heat value of 407 J instead of the correct 470 J. With the correct heat value, the change in internal energy is -268.69 J. This highlights the importance of accuracy in values when performing thermodynamic calculations.
duds1234
Messages
3
Reaction score
0
Hello, this is my first post, so I apologize in advance if it's not quite up to par.

Homework Statement



A gas is compressed at a constant pressure of 0.639 atm from 5.41 L to 2.3 L. In the process, 470 J of energy leaves the gas by heat.
a) What is the work done on the gas (J)?
b) What is the change in its internal energy(J)?

Homework Equations



a) ##W=-PΔV##
b) ##ΔU=Q+W##

The Attempt at a Solution



a)
##P = 0.639atm {\frac{1Pa}{9.872*10^-6atm}} = 64728.52512Pa##
##ΔV = V_f - V_i = 2.3L - 5.41L = -3.11L {\frac{1*10^{-3}m^3}{1L}} = -0.00311m^3##
##W = -P ΔV = -6.4728.52512Pa * -0.00311m^3 = 201.3057131J##

I submitted my answer to part a and it was correct. Part b is what I need help with. I believe that I am doing it correctly, but my answer is returned as incorrect. My incorrect work and answer appears below.

b)
##ΔU = Q + W = -407J + 201.3057131J = -205.6942869J##

Any insight into why my work/answer for part b is incorrect would be greatly appreciated!
 
Physics news on Phys.org
If your answer to part a is correct, then I can't see what's wrong with your answer to part b (see EDIT)

Is this a multi choice question that is automatically assessed?

EDIT: Just noticed that in the question statement you say that 470J of energy leaves, but in the calculation for part b you use the figure 407J
 
Last edited:
Unfortunately, this isn't a multiple choice question. I have to submit my answers electronically and a computer grades them. I have confirmation that part a is correct and that my answer for b is incorrect.
 
Ok. Can you confirm which value of heat leaving the gas is correct: 407 J or 470 J
 
  • Like
Likes 1 person
It is 470, thus this would be my error in part b. Thank you very much for helping me find my silly mistake. The correct answer would be -268.6942869J.
 
You're welcome. It happens to everyone now and then!
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top