Calculating Maximum Height and Final Velocity: 2 Energy Problems on a Slope

AI Thread Summary
The discussion focuses on two energy problems involving an ice cube on a slope and a cannonball launch. For the ice cube, the maximum height reached after being released from a compressed spring was calculated to be 0.255 meters, which is confirmed as correct. In the second problem, the speed of the cannonball striking the ground was found to be 81.216 m/s, also deemed accurate. A clarification was made regarding the unit of the spring constant, which should be N/m instead of Nm. Both solutions provided by the user were validated as correct.
rain_ex
Messages
6
Reaction score
0

Homework Statement



A 50g ice cube has no friction. It compresses a string with the constant 25 N*m a total of 10 cm. Find the max height reached by the ice cube before it starts sliding back down the slope, after it is released from the spring.

Known:
m = 50g (.05kg)
k = 25 Nm
x = 10cm (.1m)

Homework Equations



E0 = E <- general
Us0 = Ug <- expanded
1/2kx2 = mgh <- final equation

The Attempt at a Solution



I ended up with 0.255m. Is this correct? I solved for the variable "h".

Homework Statement



A cannon angled 30 degrees above the horizontal launches a cannanball at 80 m/s. if the cannon is 10 m above the ground with what speed does the cannon ball strike the ground?

Homework Equations




E0 = E <- general
Ug0 + K0 = K <- expanded
mgh+1/2mv02 = 1/2mv2 <-final equation

The Attempt at a Solution



I ended up with 81.216 m/s. I solved for the variable "v".

Please check my solutions for me! Thank you!
 
Physics news on Phys.org
Your solution is correct, but the unit of the spring constant k is N/m instead of Nm.

ehild
 
Thank you.
I'm assuming that the 2nd question's solution was correct too?
 
Yes, both solutions are correct.

ehild
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top