Newton Problem (2nd Law of Motion)

  • Thread starter Thread starter greeenmonke
  • Start date Start date
  • Tags Tags
    Law Motion Newton
AI Thread Summary
A plane with a mass of 3.5X10^5 kg is landing at a speed of 27 m/s, with a net braking force of 4.30X10^5 N. The acceleration was calculated using F=MA, resulting in 5.282 m/s^2. This acceleration was then used to determine the distance traveled in 7.5 seconds, which was found to be 53.94 m. There was a discussion about whether 27 m/s could be considered the initial velocity, which was confirmed as acceptable. A discrepancy in acceleration calculations arose, with one participant obtaining 1.22 m/s^2 instead of 5.282 m/s^2.
greeenmonke
Messages
6
Reaction score
0
the problem: a plane with a mass of (3.5X10^5)kg is landing. If the speed is 27 m/s and the net braking force is (4.30X10^5) N then a) what is the speed 7.5 sec later? and b) how far has it traveled in this time?

this is how i started, because speed is distance/time i felt that it would be better for me to fine the the distance first.
so: with the given information i solved for the acceleration using F=MA.
the a turned out to be 5.282 m/s^2. from here i used the eq: x=x0+ v0t + .5a(t^2). and this gave me the distance of 53.94 m.
then i used this to solve for a which was just 53.94/7.5= 7.192m/s.

i am just wonder if my thought process is correct. in the problem it is not stated the the 27 m/s is the initial velocity so i am wondering if it is ok if i used it as such. if anyone could shine some light on the problem or tell if i did it correctly i would appreciated.
 
Physics news on Phys.org
What you did is perfect. 27m/s IS the intial velocity. Initial velocity just means the velocity at some time t=0, but you get to pick when that time is. In this problem you essentially chose t=0 to be the instant when the plane is moving 27m/s.
 
ahh thank you so much.
 
how did you get the accerleration=5.282 m/s^2?
I try a= F/m but got a different answer: 1.22m/s^2
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top