The magnitude of the electric field

AI Thread Summary
To calculate the electric field at the center of a square with a side length of 42.5 cm, one must consider the contributions from each of the four charges: one at -38.2μC and three at -27.0μC. The electric field can be computed using the formula E = k(q/r^2), where k is the electrostatic constant and r is the distance from the charge to the center. The direction of the electric field will be towards the -38.2μC charge due to its negative charge. The superposition theorem should be applied to find the resultant electric field by calculating the magnitudes and directions of the fields from each charge separately and then combining them as vectors. The approach is confirmed to be correct, focusing on the individual contributions from each charge.
flex bro
Messages
2
Reaction score
0

Homework Statement


Calculate the magnitude of the electric field at the center of a square 42.5cm on a side if one corner is occupied by a −38.2μC charge and the other three are occupied by −27.0μC charges.

Homework Equations

The Attempt at a Solution


E=k(q/r^2) the direction of the electric field will be towards the -38.2μC charge
 
Physics news on Phys.org
Superposition theorem: calculate the electric field magnitude separately for each 4 charges and then add them as vectors
 
is there is any angles considered in analyzing the electric field
 
Sorry, I don’t understand… Just calculate the four forces separately and add them. Your formula was correct
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top