What is the magnitude of the spring force given M,K and X

AI Thread Summary
The discussion revolves around calculating the magnitude of spring force using the formula F = -kx, where k is the spring constant and x is the compression distance. For the first scenario, a 0.12 kg disk compresses a spring by 6 cm with a spring constant of 230 N/m, resulting in a spring force of 1380 N. In the second scenario, a spring with a constant of 85 N/m is compressed by 2 cm, yielding a spring force of 170 N. There is a correction regarding the misunderstanding of the compression distance, emphasizing that it should be in meters, not centimeters. The calculations for both scenarios are confirmed to be correct despite the initial confusion.
AStupidHippo
Messages
11
Reaction score
1

Homework Statement


1.In a game a .12kg disk is shot across a frictionless surface . The spring is compressed by 6cm. The spring constant is 230 N/m. What is the magnitude of the spring force?

2. A piece of plastic is attached to a spring. The spring is compressed 2cm and the released. If the spring constant is 85 N/m, what is the magnitude of the spring force acting on the toy?

Homework Equations


f=-kx[/B]

The Attempt at a Solution

[/B]

1. -230*-6
= 1380

2= -85*-2
=170
 
Physics news on Phys.org
You are just being careless. You are told that the spring constant is 85 Newtons per meter and that the spring is compressed 6 centimeters, NOT 6 meters!
 
HallsofIvy said:
You are just being careless. You are told that the spring constant is 85 Newtons per meter and that the spring is compressed 6 centimeters, NOT 6 meters!
Yes, that is quite careless of me. My formulas for both are correct tho, right?
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top