Pressure and Temperature and Heat

AI Thread Summary
An ideal gas problem involves calculating pressure changes when volume changes at constant temperature, using the ideal gas law. The second problem applies the first law of thermodynamics to determine the change in internal energy after heat is added and work is done. A third scenario requires finding the specific heat capacity of a metal after thermal interaction with water. Clarifications on the ideal gas equation emphasize that the number of molecules remains constant, simplifying calculations. Understanding these principles is crucial for solving thermodynamic problems effectively.
omgitsmonica
Messages
22
Reaction score
0

Homework Statement



An ideal gas occupies a volume of 0.3 m3 at the pressure of 400 kPa. If the volume changes to 0.85 m3 and the temperature remains constant, what is the pressure of the gas? Give answer in kPa.

OR

If 500 cal of heat are added to a gas, and the gas expands doing 394 J of work on its surroundings, what is the change in the internal energy of the gas in Joules.

OR

150 g of a certain metal, initially at 100o C is dropped into an insulated beaker containing 100 g of water at 20o C. The final temperature of the metal and water in the beaker is measured at 43o C. What is the specific heat capacity of the metal in cal/(g o C)?

Homework Equations



W = P*deltaV
Q = mcdeltaT


The Attempt at a Solution


I have no idea what's going on with any of these problems... if anyone can help me I would be awesomely grateful.
 
Physics news on Phys.org
For the first question you need to use the ideal gas equation: PV=nRT

For the second, you need to use the first law of thermodynamics: dq = dU + dW where dW is the work done by the system.

AM
 
THANK YOU THANK YOU THANK YOU.

Just one question, and then I'll do the work on my own, I promise -- for the ideal gas equation, where N determines the number of molecules, how do I figure out how many molecules there are?
 
Okay, so, for the second one, I looked through my textbook and found the equation PV=(2/3)K. I tried using that equation (because it doesn't consider temperature or N) but I came up with a ridiculously low number. Is that right, or am I completely off base?
 
omgitsmonica said:
Just one question, and then I'll do the work on my own, I promise -- for the ideal gas equation, where N determines the number of molecules, how do I figure out how many molecules there are?
You don't need to calculate n. You just need to know that it does not change. So if T does not change, what can you say about the product PV? Does it change?

AM
 
No, then it doesn't. So if nRT is constant, the two PVs should be the same.

Thank you so so much for all your help.
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Trying to understand the logic behind adding vectors with an angle between them'
My initial calculation was to subtract V1 from V2 to show that from the perspective of the second aircraft the first one is -300km/h. So i checked with ChatGPT and it said I cant just subtract them because I have an angle between them. So I dont understand the reasoning of it. Like why should a velocity be dependent on an angle? I was thinking about how it would look like if the planes where parallel to each other, and then how it look like if one is turning away and I dont see it. Since...
Back
Top