What is the percentage uncertainty in V when L1-L2 is 30?

AI Thread Summary
The discussion revolves around calculating the percentage uncertainty in the variable V, defined as V = (1/(L1-L2))^0.5, given that L1-L2 equals 30 with uncertainties of +/- 0.1 for both lengths. The method involves adding the uncertainties to get +/- 0.2, then calculating the percentage uncertainty as (0.2/30) * 100%, and adjusting for the square root by multiplying by 0.5. Participants confirm that this approach is correct, although one raises a question about the representation of the difference as 30.0 due to the uncertainty. Overall, the calculations and reasoning presented are validated, with some discussion on the notation of the final value.
Rohan1997
Messages
27
Reaction score
0

Homework Statement


My homework question says: the uncertainty in length 1 is +/- 0.1 and in length 2 is +/- 0.1 : calculate the percentage uncertainty in V where V

L1-L2 is 30

Homework Equations



V= (1/(L1-L2))^0.5 where L is the length[/B]

The Attempt at a Solution



So what I did was add the two uncertainties to get +/- 0.2
I then worked out percentage uncertainty by doing 0.2/30 *100%

and then I multiplied my answer by 0.5 since it is being square rooted.

Is this correct or have I made a mistake somewhere in my method?
 
Physics news on Phys.org
If you have learned to add uncertainties linearly, then: yes (correct) and no (no mistake) :smile:
 
BvU said:
If you have learned to add uncertainties linearly, then: yes (correct) and no (no mistake) :smile:
thanks :)
 
Your welcome, but mind you: it's an opinion: there's no guarantee

And: If the uncertainty in L1 - L2 is 0.2, why isn't this difference written as 30.0 ?
 
BvU said:
Your welcome, but mind you: it's an opinion: there's no guarantee

And: If the uncertainty in L1 - L2 is 0.2, why isn't this difference written as 30.0 ?
don't know what your talking about sorry
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top